Dock leveler not working: causes and what to check

A leveler that won't raise, sags under a load or won't put its lip out takes a dock position out of service. Here is what usually causes it, the few things you can safely check, and when to call a technician.

Typical prices: service call $150–$400 · most door repairs $200–$1,500 · dock leveler repair $500–$3,000 · new dock leveler $5,000–$15,000 installed. See the cost guide.

Request service
  • Free referral service: independent local companies pay us a marketing fee, not you
  • Independent local companies that work on commercial doors and docks
  • You get the quote directly from the company doing the work

Request service

First, make it safe

  • Stop loading at that door and block it off.
  • Never walk or work under a raised leveler unless it is held by its maintenance strut or prop.
  • If a trailer is at the door, keep the vehicle restraint engaged or the wheels chocked until the leveler is sorted out.

Hydraulic leveler won't raise

Most newer levelers are hydraulic: you press a button and a pump raises the deck. Common causes when nothing happens:

  • No power. A tripped breaker, a blown fuse, or a disconnect switch turned off. Check these first.
  • Emergency stop pressed. Many control boxes have a red stop button that has to be pulled or twisted out.
  • Low hydraulic fluid or a leak. Look for oil in the pit or under the deck. A leak needs a technician.
  • Failed motor, pump or control board. You may hear the motor run without the deck moving, or hear nothing at all.

Mechanical leveler won't come up

Older mechanical levelers use a pull chain and heavy springs. If the deck won't rise when the chain is pulled, the springs are usually broken or out of adjustment, or the hold-down mechanism is jammed. Leveler springs hold a lot of force. Do not try to adjust or replace them yourself.

Leveler drops or won't stay up

  • Hydraulic: a leaking cylinder, hose or valve lets the deck drift down.
  • Mechanical: worn springs or a worn hold-down no longer support the deck.

A deck that drops under a forklift is a serious safety risk. Take the door out of service until it is repaired.

Lip won't extend or retract

The lip is the hinged plate that rests on the trailer bed. If it won't come out, the usual causes are a bent lip or hinge from impact, a seized hinge pin, debris in the hinge, or a lip cylinder fault on hydraulic models. A bent lip is common after a trailer pulls away while the lip is still down.

Repair or replace?

Most leveler problems are repairs: a cylinder, hose, motor, springs or a hinge. Replacement starts to make sense when the deck or frame is cracked, the pit is damaged, or the same leveler keeps failing. See our repair cost guide for rough prices.

Prevent the next breakdown

Keep the pit clean and the drain open, check for oil monthly, and have the leveler serviced once or twice a year. Our maintenance checklist lists what to look at.

Need a door or dock fixed?

Use the form at the top of this page.

Request service